- Joined
- May 14, 2012
- Location
- Bilbao
DJCruicky said:Before putting it back together again today. I noticed I made a boobie, even though I was careful, I noticed I got super glue in 3 or 4 of the encoder holes. Could not even stick a pin in them to remove it . Testing wheel after putting it back together I now have big problem wheel looses centre after a few minutes driving. Was hoping it would work as the glue is transparent. Buggered it big time I did.
Apart from buying that brass one, I'm out of ideas. I guess I will be wheel less until I sort it.
Could it be that the position sensor wheel is sliding from its axe when the wheel heats up? The light is going across the holes filled with super glue, at least the sensor detects it, otherwise it would behave wrong since the very first second.
I've just read that acetone can be used to help disolve cyanoacrylate.
Check this just in case, not too cheap though. http://cmlaserservice.com/page_g25_g27_optical_encoder_wheel.html